Sony MVS-6530 - Page 194

USO RESTRITO
194
Applying Special Effects (Nonlinear Effect Settings)
No.
Parameter
Adjustment
3
a)
Direction along periphery in
which to offset ripple phase and
amount of movement
4
Speed A
b)
Ripple direction along periphery
and speed
5
Amp R
Ripple amplitude along radius
No.
Parameter
Adjustment
1
Amp R
Ripple amplitude along radius
2
Freq R
Ripple frequency along radius
3
Offset R
a)
Direction along radius in which to
offset ripple phase and amount of
movement
4
Speed R
b)
Ripple direction along radius and
speed
No.
Parameter
Adjustment
1
H
Ripple center point in horizontal
direction
2
V
Ripple center point in vertical
direction
No.
Parameter
Adjustment
1
Amp A
Ripple amplitude along periphery
2
Freq A
Ripple frequency along periphery
3
Offset A
a)
Direction along periphery in
which to offset ripple phase and
amount of movement
4
Speed A
b)
Ripple direction along periphery
and speed
No.
Parameter
Adjustment
1
Amp R
Ripple amplitude
2
Freq R
Ripple frequency
3
Offset R
a)
Direction in which to offset ripple
phase and amount of movement
4
Speed R
b)
Ripple direction and speed
5
Shape
Ripple shape
No.
Parameter
Adjustment
1
Aspect
Ripple aspect ratio
2
Angle
Ripple angle
No.
Parameter
Adjustment
1
Size R
Amount of ripple modulation
along radius
2
Offset R
Center of modulation range along
radius
3
Size A
Amount of ripple modulation
along periphery
Chapter
10
DME
Operations
Offset A
a) Set when Lock is on.
b) Set when Lock is off.
When Both mode is selected
Parameter group [1/2]
To limit the direction in which modulation is
applied
By pressing [Plus Only], turning it on, you can limit the
direction in which modulation is applied (the direction in
which the image expands) to the plus direction only.
To set the ripple center point
1 Press [Position], turning it on.
2 Set the following parameters, depending on the
selected modulation mode.
When Shape mode is selected
No.
Parameter
Adjustment
1
H
Ripple center point in horizontal
direction
2
V
Ripple center point in vertical
direction
When mode other than Shape is selected
Parameter group [2/2]
a) Set when Lock is on.
b) Set when Lock is off.
When Shape mode is selected
Parameter group [1/2]
Parameter group [2/2]
To limit the ripple range
1 Press [Range], turning it on.
2 Set the following parameters.
When Radial or Shape mode is selected
No.
Parameter
Adjustment
1
Size R
Amount of ripple modulation
along radius
2
Offset R
Center of modulation range along
radius
When Angular mode is selected
No.
Parameter
Adjustment
1
Size A
Amount of ripple modulation
along periphery
2
Offset A
Center of modulation range along
periphery
When Both mode is selected
a) Set when Lock is on.
b) Set when Lock is off.