# a selection. Uncomment the following line and set a default kernel label.
default=Gentoo
# timeout: number of seconds to wait for user input before the default
# kernel label is booted. Uncomment the following line and set timeout.
timeout=10
# The format from this point on is within a kernel label. At a minimum,
# you must pass the kernel and root device. The syntax is as follows:
#
# label='device:<path_to_kernel> initrd=device:<path_to_initrd> kernel_options'
#
# You should also pass the video options as well. An example of video
# options are as follows:
#
# 480i = ps3fb:mode:1
# 576i = ps3fb:mode:6
# 720p = ps3fb:mode:3
# 1080i = ps3fb:mode:4
# 1080p = ps3fb:mode:5
#
# You can review all possible video modes using the ps3videomode application
# provided by the ps3pfutils package. i.e. ps3videomode -v will display
# possibilities.
# The following is an example kernel label. Uncomment and edit as needed.
Gentoo='sda1:/boot/kernel-genkernel-ppc-2.6.16-ps3
initrd=sda1:/boot/initramfs-genkernel-ppc-2.6.16-ps3 root=/dev/ram0
real_root=/dev/sda1 init=/linuxrc video=ps3fb:mode:8 rhgb'
(replace video=ps3fb:mode:<required mode id>
Now press Ctrl + X. Then Y to save and exit editor.
Creating mount points for Memory Stick and SD Card (60GB version only):
(chroot) livecd etc / # cd ~
(chroot) livecd / # mkdir /mnt/memstick
(chroot) livecd / # mkdir /mnt/sd
/etc/fstab
(chroot) / # nano -w /etc/fstab
# .......
# The root filesystem should have a pass number of either 0 or 1.
# All other filesystems should have a pass number of 0 or greater than 1.
#
# See the manpage fstab(5) for more information.
#
# <fs> <mountpoint> <type> <opts> <dump/pass>
# NOTE: If your BOOT partition is ReiserFS, add the notail option to opts.
/dev/sda1 / ext3 noatime 0 1
/dev/sda2 none swap sw 0 0
/dev/sr0 /mnt/cdrom iso9660 noauto,ro 0 0
/dev/sdc1 /mnt/memstick auto noauto 0 0
(60GB version only!)
To Next Page
Loading...
