should have a solid orange, and a stripped orange. Take the solid orange.
3. Take the solid orange wire and cut the cord in half. Now strip about an inch (1 inch) off of both
ends of the solid orange wire you have cut in half. Now after you strip the solid orange wire you
will now see metal copper prons/wires.
4. Now take both ends of the solid orange wires you stripped and place the copper prons/wires on
the switch such as above, now either tape, screw, glue, and etc. Make sure you have those wires
places stuck there on all times, so you don't get disconnected.
5. Now take both ends of the solid orange wires you stripped and place the copper prons/wires on
the switch such as above, now either tape, screw, glue, and etc. Make sure you have those wires
places stuck there on all times, so you don't get disconnected.
Some other Techniques:
Fake Standby
1. get your regular Ethernet cord and unplug it from ps3
2. now get an Ethernet conjoiner
3. now go get a long, long cord and plug that in to ps3 and Ethernet conjoiner
4. now just pull the cord from the Ethernet conjoiner, and badaboom u have easy lag
5. this is for people who cant use net tools and don't have standby or switch
Use Standby With Wireless Router
To Next Page
Loading...
