To Next PageTo Next Page
Need help?Do you have a question about the Sony RM-YD017 and is the answer not in the manual?
General| Device Type | Remote Control |
|---|---|
| Brand | Sony |
| Model | RM-YD017 |
| Compatible Devices | Sony LCD TVs |
| Battery Type | AA |
| Type | TV remote control |
| Remote Control Type | Infrared |
| Weight | Approx. 100 g (with batteries) |
Specifies the required AC voltage and frequency for the TV.
Details the maximum power consumption in use and standby mode.
Lists supported video and audio formats for HDMI inputs.
Specifies the audio output levels and settings.
Details the connection type and specifications for PC input.
Specifies the connection and signal level for PC audio input.
Details the headphone jack type and impedance.
Specifies video and audio signal levels and impedance for composite/S-Video inputs.
Details signal levels, formats, and impedance for component video inputs.
Specifies the fixed audio output level for HDMI IN 1.
Describes the output format for the optical digital audio connection.
General caution statement regarding qualified service personnel.
Warning about critical components for safe operation.
Precautions for handling the LCD panel safely.
Procedures and diagrams for AC leakage testing.
Identifies control buttons on the remote commander.
Details the function and type of various LED indicators.
Explains how STANDBY LED flashes indicate error codes.
Procedure to reset diagnostic indicators after repair.
Procedures for removing the rear cover for specific models.
Procedures for removing the rear cover for specific models.
Steps for removing the arm and stand assembly.
Instructions for removing the fan unit.
Steps for removing the speakers.
Procedure for removing the HW2 board.
Steps for removing H1 and H3 boards.
Procedure for removing the UB1 board.
Steps to remove FB1, AU, and H5 boards for specific models.
Procedure for removing the TUU2 board.
Steps to remove GF1, DF1, DF2, or DF3 boards.
Procedure for replacing the inverter connector assembly.
Steps to remove H4 board and AC inlet.
Procedure for removing chassis stays.
Steps for removing the MT inverter board(s).
Procedure for removing the LCD panel and MT inverter board.
Overview of remote control buttons and indicators for service.
Steps to enter service mode and access adjustment menus.
Procedure to set model information after replacing the FB1 board.
Diagram showing the location of various circuit boards.
Information about symbols and notations used in diagrams.
High-level block diagram of the TV system.
Detailed schematic diagrams of various boards.
Exploded view of the rear cover and stand assembly.
Exploded view of the speaker assembly.
Exploded view of the main chassis components.
Exploded view showing various connectors.
Exploded view of the bezel and LCD panel assembly.
List of ceramic and electrolytic capacitors with their specifications.
List of various connectors used in the AU board.
List of diodes used in the AU board.
List of fuses used in the GF1 board.
List of ferrite beads used in various boards.
List of integrated circuits used in the service manual.
List of various jacks used in the AU board.
