5-19
3-12-4. T SOFT BRAKE ASSEMBLY, TAKE UP
REEL ASSEMBLY, T REEL GEAR
(See Fig. 3-12-4)
1) Remove the T soft spring 1.
2) Remove the clamp 2, then remove the T soft brake
assembly 3.
3) Refer to section 3-12-2 and remove the clutch mounting
assembly.
4) Pressing the T brake assembly 4 in the direction of the
arrow, remove the take up reel assembly 5 and the T
reel gear 6.
ASSEMBLY NOTE:
1. After cleaning the shafts 7 and 8, apply a drop of oil
(VHJ-0099) to each.
6 T reel gear
5 Take up reel
assembly
1 T soft
spring
3 T soft brake
assembly
4 T brake
assembly
2
Clamp
8 Shaft
7 Shaft
Fig.3-12-4
3-13. BRAKES
3-13-1. S BRAKE ASSEMBLY, T BRAKE ASSEM-
BLY, T BRAKE ACT SLIDE (See Fig. 3-13-1)
1) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
2) Remove the two clamps 1, then remove the T brake
act slide 2. (Note: You can remove the S brake assem-
bly 7 and the T brake assembly 5 without removing
the T brake act slide 2.)
3) Remove the brake spring 3.
4) Remove the two clamps 4 simultaneously, then remove
the T brake assembly 5.
5) Remove the clamp 6, then remove the S brake assem-
bly 7.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the shafts 8 and 9.
2. When fitting the T brake act slide 2, align the mark 0
with the shaft !¡.
To Next Page
Loading...
