You can make various adjustments for HDMI
settings.
• CTRL.HDMI
Lets you turn the Control for HDMI function
on or off. For details, see ''''BRAVIA" Sync
Features" (page 55).
• PASS.THRU
Lets you output the HDMI signals to the TV
even when the receiver is in standby mode.
• ON
When the receiver
is
in the standby mode,
the receiver continuously outputs HDMI
signals from the receiver's HDMI
TV
OUT
jack.
• AUTO
When the
TV
is
turned on while the receiver
is in the standby mode, the receiver outputs
HDMI signals from the receiver's HDMITV
OUT jack. Sony recommends this setting if
you use a
TV
that
is
compatible with
"BRAVIA" Sync. This setting saves power
in the standby mode compared with the
"ON" setting.
• OFF
The receiver does not output HDMI signals
when in the standby mode. Turn on the
receiver to enjoy the connected component's
source on the
TV.
This setting saves powerin
the standby mode compared with the
"ON"
setting.
Notes
• This parameter
is
not available when
"CTRL.HDMI" is set to
"CTRL
OFF".
• When "AUTO"
is
selected, it may take a little more
time for the image and sound to be output to the TV
than when
"ON"
is selected.
• When the receiver is
in
standby mode,
"HDMI"
indicator wi111ights up if "PASS.THRU" is set to
"AUTO" or"ON". However, when "PASS.THRU"
is set to "AUTO", this indicator wi11lights
off
if
no
signals are detected.
82
GB
• AUDIO.OUT
Lets you set the HDMI audio output from the
playback component connected to the receiver
via an HDMI connection.
• TV+AMP
The sound is output from
TV's
speaker and
the speakers connected to the receiver.
Notes
• The sound quality
of
the playback component
depends on the
TV's
sound quality, such
as
the
number
of
channels, and the sampling frequency,
etc. When the TV has stereo speakers, the sound
output from the receiver is also stereo as that
of
the
TV,
even
if
you play back multi channel
software.
• When you connect the receiver to an image
display component (projector, etc.), sound may
not be output from the receiver. In this case,
select "AMP".
• AMP
The HDMI audio signals from the playback
component are only output to the speakers
connected to the receiver. Multi channel
sound can be played back as it is.
Note
Audio signals are not output from the TV's
speakers when "AUDIO.
OUT"
is set to "AMP".
• SW LEVEL
Lets you set the level
of
the subwoofer to 0
dB
or +I0
dB
when multi channel Linear PCM
signals are inputvia an HDMIconnection.
You
can set the level for each HDMI input
independently.
• SW AUTO
Automatically sets the level to
0 dB or
+10
dB
depending on the frequency.
•
SW
+10
dB
•
SWOdB
Note
This parameter is only available when HDMI input
signals are detected.
To Next Page
Loading...
