Enjoying
the
system's
sound
in
another
room
(For the S-AIR receiver only (not
supplied»
You can enjoy the system's sound in another
room by using the S-AIR receiver. The S-AIR
receiver can be placed
in
another room for
enjoying the system's sound there.
For details
of
the S-AIR receiver, refer to the
operating instructions supplied with the S-AIR
recelVer.
1 Set the
10
of the S-AIR receiver
to match the
10
of the S-AIR
main unit.
•
To
set the 10
of
the S-AIR main unit,
see "To set the
ID
of
the S-AIR main
unit" (page 61).
• To set the
10
of
the S-AIR receiver,
refer to the operating instructions
supplied with the S-AIR receiver.
Notes
• When you are using another S-AIR sub unit,
such as a surround amplifier, do not change
the ID
of
the S-AIR main unit. Set the ID
of
the S-AIR receiver to match the ID
of
the
S-AIR
main unit.
•
When
you pair the S-AIR main unit and
another
S-AIR
sub unit, such as a surround
amplifier, you also need to pair the S-AIR
main unit and the S-AIR receiver.
For
details,
see "Pairing the S-AIR main unit with a
specific S-AIR sub unit (Pairing operation)"
(page 62).
2 Press AMP MENU.
Operation
Change the function
of
the
system.
Share the same operations on the
remote.
~,II,.,
~/~
Press
S-AIR CH
3 Press
+/+
repeatedly to select
"S-AIR", then press
~
or
+.
4 Press
+/+
repeatedly to select
"MODE", then press
~
or
+.
5 Press
+/+
repeatedly to select
the setting you want.
• PARTY: The S-AIR receiver outputs
sound according to the input selected on
the S-AIR main unit.
• SEPARATE: You can select the input
you want for the S-AIR receiver while
the input
of
the S-AIR main unit remain
unchanged. When at SEPARATE
mode, you can only select
"SA-COl
CD", "DMPORT", "FM TUNER",
"AM TUNER" and the input that is
currently selected at the S-AIR main
unit.
Note
When
"FM
TUNER"
or
"AM
TUNER"
is
selected on the S-AfR main unit, you can
only select the same band for the tuner on the
S-AIR receiver. However, you can select
input other than
TUNER
on the S-AIR
receiver.
6 Adjust the volume on the
S-AIR receiver.
Notes
•
The
sound
of
the S-AIR receiver may be cut
off
by
operation
of
the S-AIR main unit.
• When the sound is other than 2 channel stereo,
multi channel sound is downmixed to 2 channel.
• Signals with a sampling frequency
of
more than
96 kHz cannot output to this S-AIR receiver.
To control the system from the
S-AIR receiver
You can control the system from the S-AIR
receiver by using the following buttons.
For details, refer to the operating instructions
of
the S-AIR receiver.
I
01
I
,
AMP
c:.o+-+t--
MENU
(
MENU)
C::C
C::L.c:r.c::J
t:D
\:D,
.1+1.1.
64
GB
To Next Page
Loading...
