Indicates on/off status where green icon and white value = ”On” and gray icon and value = “Off”. The HPF frequency is variable in 10
Hz steps from 10 Hz to 320 Hz.
7: Polarity Reverse
Indicates polarity status. Green icon = polarity reversed, white icon = polarity normal.
8: Channel Input Delay
Indicates input delay time. The input delay is continuously-variable in milliseconds from 0-50 ms.
9: Channel Limiter
Indicates on/off status of channel limiter.
10: Channel Compressor
Indicates the Compressor position in the audio chain. Pre(fade) or Post(fade). Select to enter Channel Compressor screen.
11: Mute
Indicates mute status of channel. Blue icon = muted. Toggle mute on/off with the “Tone” switch.
12: L C R Select
Indicates the stereo pan position of the channel’s contribution to the L/R mix. Orange = selected. Use the */** switch to select. Hold
*/** switch and rotate Select knob for continuous panning positioning. Alternatively, press and hold Select knob, then use */** switch
to pan continuously. Rotating the select knob while holding */** will change the balance of Mid, Center and Side when two channels
are MS linked.
13: Arm
Toggle the Rtn/Fav switch to arm or disarm isolated track for recording.
14: Channel Copy
Select to copy parameters from the current channel to any combination of other channels.
15: HP Preset
Pressing the HP knob toggles between HP preset and PFL. Can be used to listen to channel panning while viewing the Channel
Screen by setting the HP Preset to LR Stereo.
16: Channel To Bus Routing
Determines the bus or buses channel audio will be sent. When a channel is routed to a bus as a Send (bus box highlighted blue),
the Send Gain value is used. When a channel is sent Pre-fade (green) or Post-fade (orange), the Send Gain value is ignored.
17: Noise Suppression (NA or NX)
Indicates whether the channel is selected for Sound Devices NoiseAssist (NA) or CEDAR sdnx (NX) and how much is applied. Field
is grayed out when the Noise Suppression is disabled. White ‘--’ (dashes) when Noise Suppression is enabled but channel not
selected; white ‘dB’ value when channel is selected. NoiseAssist and CEDAR sdnx are optional paid Plugins.
18: Automix
Indicates whether the channel is selected for automixing.
Purple text = On and white text = Off.
19: Channel EQ
Indicates the EQ position in the audio chain. Pre- or Post-fade. Select to enter Channel EQ screen.
20: ISO (channel->ISO) Routing
Indicates where the isolated track’s audio is tapped from in the audio chain. Pre- or Post-fade.
21: Channel Fader Value
Indicates the level of the channel fader control, continuously-variable from -inf to +16dB. Channels 1-6 fader is adjustable using the
front panel fader controls. Channels 7 & 8 faders are adjustable in the channel screen using the Select knob.
To Next Page
Loading...
Need help?
General
