Mix Pan Mode. For adjusting channel pans by rotating the VPots. Press a VPot to set pan to center. Faders, mutes and solos
continue to control the channel mix, mutes and solos.
Mix Low Cut Mode. For adjusting channel low cut frequency by rotating the VPots. Press a VPot to toggle Low Cut On/Off. Faders,
mutes and solos continue to control the channel mix, mutes and solos.
Bus Mode. For adjusting Bus levels B1-B4, L,R. Switches faders to Bus faders. Mutes and Solos buttons are Bus mutes and solos
respectively.
Bus Sends-on-Faders Mode. Faders are channel sends to the selected bus. Ideal for creating different IFB feeds/mixes.
Channel Bus Sends Mode. VPots adjust a channel’s send gains to each bus. Press VPot to toggle between Off, Pre, Post and
Send. Rotate VPot to adjust bus send gain. Use the Select buttons to select which channel’s send gains to adjust.
Output Mode. For adjusting Output levels X1-X4, L,R. Switches faders to Output level controls. Mute buttons are output mutes.
EQ Mode. For adjusting channel EQ using the VPots. Use the Select buttons to select which channel’s EQ to adjust. Faders
continue to control the channel mix.
Supported Third-Party Controllers
The 833 supports a variety of third-party external controllers that conform to the MCU protocol. Multiple controllers may be
connected simultaneously for extended control.
SONOSAX SX-LC8+
Eight channel compact fader bank with faders and channel selects for channels 1-8 plus controls for slate mic, record, and stop. The
Mic, Rec, and Stop buttons are mappable to other functions using the Mapping menu.
Ensure the Sonosax is set to USB Midi mode
1. Press and hold buttons 6 + 7 + 8 and connect the USB cable to the 8-Series USB-A port. The mode change is confirmed
by a blinking REC
2. Reboot the 8-Series.
Icon Platform M+ and D2 Display
Eight channel fader bank with control over gain, bus, sends, coms, trim and pan. Dedicated Select, Mute, Solo and Arm buttons for
each channel. Bank switch between 833 channels 1-8 and 9-12 if the +4 plugin is installed. Icon M+ Operation is covered in the
Icon M+ User Guide: https://cdn.sounddevices.com/wp-content/uploads/2019/05/Icon-User-Guide.pdf
Icon Platform X+
Eight channel expansion fader bank with single assignable knob and Select, Mute, Solo and Arm buttons.
Icon Platform B+
Assignable illuminated 50 pad button surface. Allows a user to custom map up to 50 functions.
Connects via USB-A cable, not mini DIN.
Behringer X-Touch
Eight channel trim and fader panel with master volume and additional mappable buttons. Bank switch between 833 channels 1-8
and 9-12 if the +4 plugin is installed.
Mackie MCU Pro
Eight channel trim and fader panel with master volume and additional mappable buttons. Bank switch between 833 channels 1-8
and 9-12 if the +4 plugin is installed.
Waves MidiPlus Fit
Sixteen channel trim and fader panel with main fader and additional mappable buttons. Note that the Waves MidiPlus Fit must be
running firmware v1.1.3 or later and set to MCU mode. To enter MCU mode, hold down the ‘Solo’ button of channel 1 and the ‘2’
button of channel 2 simultaneously while turning on the FIT.
Refer to the ‘Waves MidiPlus Fit Controller for the 8-Series - User Reference’ for more information.
To Next Page
Loading...
Need help?
General
