Automixer
Selects the Automixing mode and the channels included in the auto mixer group(s).
Mode
Selects the Mode of Automix [MixAssist, Dugan Automixer] and whether it is disabled* or enabled.
Note: Set a toggle shortcut or mapped controller button to enable/disable the selected automixer mode to allow you to quickly
compare the effect of the automixer being on or off.
Ring LED Indication
Set to On to display automix meter levels on the ring LEDs. Set to Off if you prefer to only see automix levels in the LCD meter
views.
Channel Selection
Selects which of channels 1-8 are included into the automix group(s). A channel can also be selected for automix from channel
screens 1-8. Enter a channel screen 1-8 then use the Select knob to scroll to and toggle the Automix on or off for that channel.
Purple text is On, white text is Off.
Note: If a channel is enabled for automixing, it sets post-fade routing of that channel to Bus L and R in the Channel Bus Sends menu
and the Bus L and R routing menus. Channels can still be unrouted or routed pre-fade to Bus L and R but note that automixing only
applies to post-fade channels.
Note: Automixer is only available with sample rates of 47952, 48000, and 48048 Hz.
Dugan Automixer Mode
Dugan gain display bars is overlaid on top of the channel signal meters. The top 15 dB of the meter scale is shared between Dugan
gain display bars and audio signal metering. Dugan gain display bars range from 0 dB (at the top, aligned with 0 dBFS, no
attenuation) to -15 dB (max attenuation). The -15 dB value is indicated by a purple horizontal graticule mark near the top of a
channel’s signal meter when that channel is enabled for Dugan in Menu>Automixer.
To Next Page
Loading...
Need help?
General
