SL-2 Options
Provides access to various SL-2 settings.
Receiver Slot Power
Each slot can be individually turned On/Off to save power when not in use. Powering receivers on and off from the receiver’s user
interface is not supported.
DC Outputs
Enable/disable DC Outputs 1 and/or 2.
Antenna A/B Power (bias)
Provides 12 V DC bias power for active or smart antennas.
Antenna Attenuation
Apply attenuation to reduce the possibility of RF overload. Select from 0 to -18 dB in 6 dB steps.
Antenna Filter
Select the SL-2’s front end filter to reduce the likelihood of out-of-band RF noise affecting range. Select from Wideband, 470-614
MHz, 542-694 MHz, 606-770 MHz, 770-960 MHz, 1240-1525 MHz.
Antenna LEDs
Antenna LEDs can be toggled On*/Off.
Remote Antenna Control
Enables/disables Remote (Smart) Antenna Control.
Remote Antenna Setup
See “Remote Antenna Setup” details below.
RF History Duration
Sets the duration of the RF HISTORY plot. Select from 30 to 600 seconds in 10 second steps, default duration is 30 seconds.
Use Wireless Names
The name associated with the receiver channel is automatically applied to the isolated track receiving the signal. This feature is
supported by the Audio Ltd. A10-RX, A20-RX, Shure ADX5D, and the Wisycom MCR54.
To Next Page
Loading...
Need help?
General
