4. Bus
L,R, 1,2 (available on buses 3-4).
5. Com
Rtn (not available on L,R buses).
6. Return
Rtn 1-2 (not available on L,R buses)
7. Slate
Activates the slate mic. Slate mic will follow settings from Slate/Coms/Returns menu.
8. More..
Select to bring up a second page of Bus toggle switch functions including:
Name: Select to name the bus
NoiseAssist (NA) or Cedar SDNX (NX) In Bus 1-4 screens, use ** toggle to adjust the amount of NoiseAssist
or CEDAR sdnx applied to the selected bus.
Bus Compressor (Comp): Select Rtn toggle to set compressor parameters for the selected bus. Available bus
compressor parameters:
Mic Toggle: Selects Compression On or Off.
Tone: Selects threshold [0 to -40 dB]
* Toggle: Selects Ratio. [1.0:1 to 20:1 in 0.1 steps]
**Toggle: Selects Knee. [Hard, Soft]
RTN Toggle: Selects Attack time [1 to 200 ms in 1ms steps]
FAV Toggle: Selects Release time [50 to 200 ms in 1 ms steps, 200 to 1000 ms in 10 ms steps]
Limiter control.
Bus Limiter (Limit): Select Fav toggle to toggle Limiter On or Off.
9. Send (Bus Send on Fader)
Channel Bus Sends in Bus screens. Use the Sel knob to navigate through the Bus send routing. When an ISO set to Send
(highlighted in light blue) is selected, activate the * toggle then rotate the HP knob to adjust the gain of the ISO sent to the
bus. Toggle the * switch again to exit Bus Sends on Faders.
10. NoiseAssist (NA) or Cedar SDNX (NX) In Bus L and R screens, use ** toggle to adjust the amount of NoiseAssist or
CEDAR sdnx applied to the selected bus.
11. Gain
Use ** toggle to select and adjust selected bus gain in 1 dB increments. [Off-16 dB]
12. Mute Coms
Selects muting of Coms 1, 2 sends and returns.
13. Mute All
Indicates mute status of bus. Blue icon = muted. Toggle Mute All On/Off with the “Fav” toggle.
To Next Page
Loading...
Need help?
General
