Jam A20-Mini
This menu is available when an A20-Mini is connected via USB-A to the 833. Displays the timecode and frame rate of 833 and
A20-Mini along with the calculated difference. Toggle the Jam A20- Rtn/Fav switch to jam the A20-Mini.
Set Generator TC
Provides the ability to start rolling internal TC from a manually entered value in the format of HH:MM:SS:ff.
Set Generator UBits
Provides UBits manual and automatic entry. [U=User entered UU:UU:UU:UU*, mm:dd:yy:UU, dd:mm:yy:UU, Use External] Use
Rtn/Fav toggle to exit.
Lemo Options
Selects pin-2 and pin-5 options for TC Lemo connector.
1. Pin-2 - [TC In*, WCK In, WCK Out]
2. Pin-5 - [TC Out, WCK Out]
Display Mode
Selects whether to display Big Timecode or Big A-Time.
Sync Reference
Selects current sync reference for all transport modes (record, stop and play). [Internal*, Word Clock, LTC In, AES 1,2 (XLR 1)] Ring
LEDs flash yellow while locking to the selected sync reference. Once locked, the LEDs will stop flashing. Should the LEDs flash
indefinitely, the selected sync reference has not been detected. Locking can take up to 30 seconds.
Note: Expansion port accessory AES inputs cannot be used as a sync reference source.
Holding TC While Powering Down
When the 833 is shut down and external DC (TA4 connector) is not connected, the 833 holds timecode accurately for four hours
before resetting, provided the internal timecode backup battery is charged.
The internal timecode battery charges when:
1. The 833 is on and powered by L-Mount batteries or the TA4 DC In.
2. The 833 is off, power is connected to the TA4 DC In, and the Power>Batt Charging option is set to Always or When Power
is Off.
To Next Page
Loading...
Need help?
General
