Scorpio User Guide
24
Q-marks
Use Q-marks, (also known as cue marks) to mark points of interest
within a recording. Q-marks can be added and deleted during record-
ing, playback, pause, or scrub mode when viewing the Home screen.
Once added, they can easily be located to during playback on the
8-series. Q-marks are also embedded in the WAV le and can be read
by audio editing applications such as Reaper and Adobe Audition.
Note: Q-marks are only supported when using the BWF WAV format,
not the RF64 WAV format.
Note: Q-marks in auto-split les (due to BWF 4GB max size) are not
supported.
To add a Q-mark, hold Select and press >>.
The Q-mark number is displayed in blue at the top of the meter view
to the right of the take name. Each time a new Q-mark is added, the
Q-mark number is incremented. (Q01, Q02, Q03)
To delete a Q-mark, hold Select and press <<.
Q-marks can also be added and deleted using Toggle Switch Action
shortcuts, Midi mapped buttons, and USB Keyboard buttons ‘Q’ and
‘delete’.
LOCATING TO Q-MARKS DURING PLAYBACK, PAUSE, OR
SCRUB:
To locate to the next Q-mark, press >>. If there is no next Q-mark,
pressing >> will locate to the end of the take and will pause playback.
To locate to the previous Q-mark, press <<. If there is no previous
Q-mark, pressing << will locate to the beginning of the take.
Tip: To check the last few seconds or minutes of a long take, Press >>
after the last Q-mark has been passed. This will pause playback at the
end of the take. Then rewind or reverse scrub to the point of interest
and press play.
To Next Page
Loading...
Need help?
General
