Operation
21
FIG.19
Stopping the Machine
There are several ways to stop the machine.
1. Press the emergency stop button
Upon pressing it, the machine will initiate the stop function, causing the drive wheel and brush
motor to cease operation. If the emergency stop button is pressed while the machine is
performing a cleaning task, the vacuum motor will briefly run before coming to a stop in order
to minimize residual water on the floor.
2. Pause the task
When the machine is executing a task, tap pause task icon on the homepage to pause it, and
the machine will stop in place. After tapping resume task icon, the task will resume.
3. End the task
When the machine is executing a task, tap the end task icon on the Homepage to end the task.
Then the machine will return to the docking station automatically.
4. Go home
Tap the ‘Go home’ icon, and the machine will end the task and return to the docking station.
For safety: Do not stop the machine on the slope for more than 30 minutes.
To Next Page
Loading...