Maintenance
30
3) Remove the skirt from the scrub head.
2. Clean the skirt using a brush and rinse with fresh water.
3. Reinstall the skirt into the machine. Make sure it is securely in place before resuming the
operation of the machine.
FIG.27
Notice: To clean the bristles properly, it is essential to brush in the direction of the bristles, as
shown by the arrows in FIG.28.
FIG.28
Skirt Replacement
1. Remove the front skirt from the machine.
To remove the front skirt, follow the steps below:
1) Ensure the scrub head is in the raised position.
2) Loosen the front skirt retainer knobs, as shown in Fig.27.
3) Remove the skirt from the scrub head.
2. Reinstall a new skirt into the machine. Make sure it is securely in place before resuming
the operation of the machine.
Brush/Pad Maintenance
This machine is equipped with two brushes or two cleaning pads and they are located at the
bottom of the machine. Please check the brushes daily for any tangled material, such as hair
or wire, as well as for any damage or wear.
For safety: Before maintaining or leaving the machine, stop on the level ground and turn off
the machine.
1. Ensure the scrub head is in the raised position.
2. Remove the side skirts from the scrub head.
To Next Page
Loading...