Spark L50 - Maintenance

Maintenance
26
Maintenance
The machine needs to be maintained regularly to keep the best of the performance and the
service life.
CAUTION: When updating the software, make sure the battery level is more than 30%
and do not shut down the machine as it may cause damage to the system.
For safety: Before maintaining or leaving the machine, stop on the level ground and turn off
the machine.
For safety: Before maintaining the machine, read the user manual and understand fully.
For safety: When maintaining the machine, wear suitable gloves.
Maintenance Schedule
Interval
Parts
Procedure
Person Resp.
Daily
Recovery tank
Drain, rinse, clean float shut-
off screen.
Operator
Debris filter bag
Clean
Operator
Squeegee
Clean, check for damage and
wear
Operator
Side skirt
Clean, check for damage and
wear
Operator
Front skirt
Clean
Operator
Disk brushes
Check for damage and wear
Operator
Pad
Check，flid or replace
Operator
Workstation recovery
tank (If equipped)
Clean, rinse
Operator
Covers
Clean the machine covers
Operator
Weekly
Battery*
Charge
Operator
LiDAR
Clean
Operator
Cameras
Clean
Operator
Monthly
Front skirt
Check for damage and wear
Operator
Solution tank filter
Clean
Operator
Solution tank
Rinse
Operator
Recovery tank lid seal
Check for wear
Operator
Recycling system
filters*
Replace
Operator
Yearly
Vacuum motor
Replace
Trained Personnel
Brush motor
Check，replace
Trained Personnel
Battery*: if the machine is not equipped with workstation or charging station, the battery
needs to be charged to 100% at least once a week.
Recycling system filters*: It is optional, and the maintenance interval may vary depending on
the type of the floor.