Spark L50 - Page 37

Maintenance
36
Charger is damaged
Contact local dealer to replace
the charger
Battery failure
Contact local dealer or
CenoBots for technical support
Poor water pick-
up
Squeegee blade is damaged or
worn
Replace or reverse the blade
Recovery tank drain hose leak
Secure hose cap or replace
Vacuum hose clogged
Clean the hose
Debris caught in squeegee
Clean the squeegee
Damaged the vacuum hose
Replace the vacuum hose
Defective seals on recovery tank lid
Replace the seal
The recovery tank is full due to the
failure of the sensor
Contact local dealer or
CenoBots for technical support
Excessive foam buildup
Use the low or no foam
detergent or add defoamer to
the recovery tanks
Poor scrubbing
performance
The brushes or pads were worn or
damaged
Replace the brushes or pads
Machine is moving too fast
Slow down the machine
Using wrong brush or pad
Use the right brush or pad
Not enough solution
Increase the solution flow