Safety
5
2. Before start up the machine:
⚫ Check machine for fluid leaks.
⚫ If safety-relevant covers, such as disk brush deck, power supply cords, are
damaged, stop the machine and report.
⚫ Ensure that all covers are positioned in the designated locations as specified in the
instructions.
3. When operating the machine
⚫ Use it as described in this manual.
⚫ Do not stop on slopes.
⚫ Pay attention to the local situation, as well as to third persons and children. In the
vicinity of blind spots such as doors or curves in particular, it is important to reduce
speed.
⚫ Reduce speed on the inclines and slippery ground.
⚫ Go slowly on slopes and slippery surfaces.
⚫ Use care when reversing machine.
⚫ Do not transport other persons and objects with this machine.
⚫ Keep children and unauthorized persons away from machine.
⚫ Do not operate manually the machine on the ramp with a gradient exceeding 10%.
⚫ Do not run it in auto mode on the slope with a gradient exceeding 2%.
4. After using the machine:
⚫ In order to prevent unauthorized use of the machine, the power source shall be
switched off or locked, for example by removing the key of the main switch or the
ignition key.
⚫ Stop the machine on level ground.
⚫ Machine that is left unattended should be secured to prevent unintended movement.
5. When maintaining the machine
⚫ Turn off the machine and remove the key.
⚫ Stop on the level ground.
⚫ Do not jack up machine.
⚫ Do not clean the machine with a pressure washer.
⚫ Use accessories and consumables supplied or authorized by CenoBots. The use of
other accessories may impair safety.
⚫ Do not dismantle the machine without permission. If you need service, please contact
the local distributor.
⚫ Do not use incompatible battery chargers as this may damage battery packs and
potentially cause a fire hazard.
⚫ Avoid moving parts, do not wear loose clothing or jewelry, and secure long hair.
6. When loading/unloading the machine onto/off truck or trailer:
⚫ Turn off the machine and remove the key.
⚫ Drain the water tank before loading.
⚫ Do not operate the machine on the ramp with a gradient exceeding 10%.
⚫ Block the machine wheels well.
⚫ Use tie- down straps to secure machine.
To Next Page
Loading...