H.264 Network Digital Video Recorder User Manual
Page 29
【Delay】When alarm is over,recording will last some seconds(10~300sec),then stop.
【Show message】Pop the alarm information dialog box in the local host computer screen.
【Send EMAIL】■ means sending an email to user when the alarm is turned on.
Note: Set in the [NetService] and send email.
4.3.2 Video Blind
When the video image is influenced by the environment such as bad brightness or reaching the set sensitivy
parameter, the camera mask function is turned on and the linkage function is turned on.
Picture 4.9 Video Blind
Set method: refer to chapter 4.3.1. Motion detect
Note:"Advanced" button is the same as rightclick.
4.3.3 Video Loss
When the equipment can not obtain the channel video signal, the video loss alarm is turned on and the linkage
function is turned on.
Picture 4.10 Video loss
To Next Page
Loading...
