SPE EXPERT 1.3K-FA - Transceivers of Other Brands

User manual
Expert Amp 1.3K-FA
Page. 40 of 87
(about 3 seconds) must be allowed for the “[PC=xxx]” indication to expire before
another adjustment can be made.
The following picture is an example of the Power Control setting relative to the same
band (20 m), but using the LOW mode selection instead.
Once the correct preset has been adjusted, initiate the TX mode (RTTY, CW) to verify
the output power.
ATTENTION! It is strongly recommended to start with a low preset value (e.g. 10) and
progressively increase its value. This is to avoid overdriving the linear amplifier.
The following empty table is suggested as a template for the FlexRadio user’s Power
Control adjustments.
Band
160 m
80 m
60 m
40 m
30 m
20 m
17 m
15 m
12 m
10 m
6 m
MAX
MID
LOW
12.6 Transceivers of other Brands
A special link is not necessary as the internal amplifier frequency counter will measure
the input frequency and will control the amplifier.
Note: WARNING, SPE is not responsible for any failure resulting from misuse of hardware
interfacing.