Page. 50 of 87
15. USE OF THE USB / RS232 PORTS
Through the USB / RS232 ports on the rear panel it is possible to interface the amplifier
with a PC.
Two features are possible:
a) To remote the linear.
b) To download newer and updated firmware releases.
The USB port is recommended in order to directly link the linear with a PC.
In this case the Soft Ware “ KTerm_1.3K_USB” must be used.
The RS232 port (see “13.5 PORT Connector”) is more suitable for Internet use.
In this case the Soft Ware “KTerm_1.3K_232” must be used.
It is not proper to use both ports simultaneously !!
Use is restricted to being used by only one port at a time.
These programs can be downloaded from www.linear-amplifier.com .
Note: For Internet use, please refer to the manual of the remoting equipment.
To Next Page
Loading...
