INDEX Page. 76 of 92
When the above described steps are completed, Term_1.5K_USB,exe will only be able to
recognize and address the EXPERT linear amplifier whose unique ID String matches the
one written after the USB_ID: label of the picture above.
As explained earlier, this setting is permanent. So there is absolutely no need to repeat the
acquisition procedure described as long as the user connects to that specific unit.
Of course the acquisition procedure must be restarted again in the case of another
EXPERT linear amplifier be required to be addressed in the same selective way; this is
because a different device has acquired, by force of circumstances, another ID String
parameter to be reconsidered.
After having carried out all the setting and configuration steps listed in the earlier pages,
you should be all set for using the FT232RL selective addressing features as described so
far.
All the operations tied to the Connect / Disconnect menu items are still the same as in
the case of the non-selective addressing procedure.
To Next Page
