1
2
3
4
4
B
A
C
6
5
DROPPER HOUSING GUIDE
DROPPER HOUSING GUIDE ASSEMBLY
1: Make sure the tube is completely inserted into the dropper housing guide. Failure to do so will cause housings to snag.
2: Thread the dropper housing from the ICR guide through the guide tube exiting at the top of the dropper housing guide.
3: Guide the housing through the L-bend on the dropper housing guide first, then feed the housing up into the seat tube.
4: Hook the dropper housing over the two center hooks on the guide.
5: Place the dropper housing guide against the upper inside wall of the downtube, aligned with the bottle cage bolts.
6: Insert the bottle cage bolts through the cage and frame and into the dropper housing guide (6). Tighten the bottle cage bolts to specification.
# PART NAME PART NUMBER QTY SPEC TOOL
TORQUE
COMMENT
Nm in-lbf
A Nylon Guide Tube Different lengths per size N/A N/A N/A S1 - 385 mm | S2 - 395 mm | S3 - 410 mm | S4 - 430 mm | S5 - 465 mm | S6 - 480 mm
B Dropper Guide
S216500005
1 N/A N/A N/A
C Dropper Guide Bolts 2 M5 X 10 mm x 0.8 mm P 3 mm hex 2.8 25 Insert bolts through the water bottle cage before inserting through the frame.
PAGE 3
2022
TECHNICAL GUIDE
To Next Page
Loading...
