To Activate the Expo Function
Rotate the roller to highlight EXPO then press the roller to access the Throttle Curve Expo
function. Select Inh or Act to inhibit or activate the Expo function then press to accept.
Adjusting the Curve
Move the flight mode switch in the position you wish to adjust. Rotate the roller to highlight one
of the five available throttle curve values (Low, 25%, 50%, 75%, High). Press the roller to access
that value.
CURVE
The DX8 features a 5-point throttle curve. You can assign up to four separate throttle curves. A
graph displays at the left side of the screen to aid in adjusting throttle curves. An Expo function
is also available that smoothes out
the curve. To Program Throttle
Curves
With the transmitter on and the main
or telemetry screen displayed, press
the roller.
The Function list displays.
Repeat this for all desired points.
To Activate the Expo Function
Rotate the roller to highlight EXPO then press to access the Throttle Curve Expo function.
Select Inh or Act to inhibit or activate the Expo function. Press the roller to accept.
Selecting a Flight Mode
Highlight the desired flight mode at the top of the screen then press the roller to select. The selected flight mode will darken confirming your selection. N= Normal 1 = Stunt 1 2= Stunt 2 H= hold
The DX8 flap system offers up to three programmable flap and elevator positions (normal, mid and land). You can assign them to a variety of switches. You can program a Speed function to slow
flap and elevator compensation travel for a scale effect. A graphic display on the left side of the Flap System screen provides a visual display of servo position aiding in setting up and adjusting the
flaps.
Note: The Flap function is only available on wing types with flaps. (see Wing Type page 15)
To Activate the Flap Function
With the transmitter on and the main or telemetry screen displayed, press the roller. The Function list displays.
To Next Page
Loading...
