Assigning a Channel- (Output)
You can assign the receiver channel the
gyro gain is plugged into in this screen.
The governor and the gyro must use two
different channels. A channel used by the
governor function does not appear in the
Gyro list. Highlight Ch: (channel) then
press to access the gyro channel function.
Select the desired channel to plug the gyro
gain into, normally the Gear channel is
used.
Adjusting the Rate Values
Rotate the roller to select the desired gain
value then press. Select the gain value.
Any time a T displays, the gyro is in tail
lock (Heading Lock). If an N displays, the
gyro is in normal mode.
Gyro
Rd+H
POS 0: 75. 0 X 4- POS
H 7 0 . 0 X 1
POS 2:
70. 0 X
Ch: Gear________Su: Gyro
TIMER
The DX8 Timer function allows you to
program a Count Down timer or Stop
Watch (count up timer) to display on the
main screen. An alarm sounds when the
programmed time is reached. You can
program the timer to start using the trainer
switch, the left or right trimmers or
automatically when throttle is raised above
a preprogrammed position. Also, an
internal timer that shows run time for a
specific model displays on the main
screen.
To Access the Timer Screen
With the transmitter on and the main or
telemetry screen displayed, press the roller.
The Function list displays. Rotate the roller to
highlight Timer then press.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
