Step 8. Reinstall the gimbal cages and upper
circuit boards, then the back of the
transmitter. Be careful not to pinch
wires or the rubber side grips.
Tighten the 6 Phillips head screws
then reinstall the rear and side grips.
PROGRAMMING
CONVERSION
When making a mode conversion, the
programming must also be changed and when
changing throttle elevator positions the transmitter
must be recalibrated in the systems setting screen.
To Access the System Settings Function
Press and hold the roller while turning on the
transmitter. When System Setup appears on the
screen, release the roller. The DX8 is now in
System Setup Mode. Highlight System Settings
then press the roller to access the System Settings
function. The System Settings screen will appear.
To Select a Mode
In the Systems Settings screen rotate the roller to
highlight Mode then press the roller to select the
Mode function.
System Settings
It1=1
User Name: John Adams
Language: English [R ekt
Rotate the roller to select the desired mode then
press the roller to accept the mode.
To Next Page
Loading...
