EasyManua.ls Logo

Spektrum DX9 - Mixing; Offset; Trim; Assigning A MIX To A Switch

Spektrum DX9
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
SPEKTRUM DX9 • TRANSMITTER INSTRUCTION MANUAL
EN
Mixing
Mixing allows control input for a channel to affect more than
one channel at a time. Mixing functions support:
• Mixingachanneltoanotherchannel.
• Mixingachanneltoitself.
• Assigningoffsettoachannel
• Linkingprimarytosecondarytrim.
These mixes are available for each model memory:
Select a channel for master and slave. Inputs for the master
channelcontrolboththemasterandslavechannels.Forexample,
Elevator to Flap makes elevator the master channel and flap the
slave channel.
• 10programmablemixes
• CyclictoThrottle(HELI)
• Swashplate (HELI)
• ElevatortoFlap(ACRO)
• AilerontoRudder(ACRO)
• RuddertoAileron/Elevator(ACRO).
• Aileron>Rudder (SAIL)
• Aileron>Flap (SAIL)
• Elevator>Flap (SAIL)
• Flap>Elevator (SAIL)
Offset
Changetheoffsetvaluetomovetheeffectivecenterposition
of the slave channel. Positive or negative value determines the
directionoftheoffset.Offsetisnotavailableforcurvemixes.
Trim
If the master channel trim should also adjust the slave channel,
set Trim to Act. A channel monitor on the left side of the screen
shows how channels respond to input. To view a switch-assigned
mixonthemonitor,themixswitchmustbeintheactiveposition.
Assigning a Mix to a Switch
If you wish to assign a mix to a switch position:
1.Makesureyouareinthedesiredmixscreen.
2.Movetheswitchyouwanttoassignthemixto.
3.Scrolltotheswitchpositionwhereyouwantthemixtobe
active.
4.Pressthescrollwheeltoactivatethemix.Whentheboxis
lled,themixisactive.
ThemixisActivewhentheboxislledandInactivewhenthe
boxisopen.Youcanassignamixtobeactiveinmultipleswitch
positions (0,1 or 2).
Tip: Use Auto Switch Select to select the switch.
CAUTION: AlwaysdoaControlTestofyourmodelafter
changingmixes.
Back Mixing
BackMixingappliesamixtoallrelatedservosinawingortail
type.Forexample,ifyouselect2AIL,2FLAPintheAircraftType
screen,amixtooneaileronchannelaffectsbothaileronservos.
Themixresponse,however,dependsontheaileronchannel
includedinthemix.
ABackMixalsoenablesyoutousefewermixestoachievethe
desiredresponse,forexampleaddingrolltoasplitelevator.

Table of Contents

Other manuals for Spektrum DX9

Related product manuals