To adjust travel values:
1. Touch TRAVEL in the ribbon at the
top of the Servo Setup menu.
2. Select the high or low side of the
channel.
3. Touch the lock icon (
) to adjust
both directions at the same time, if
desired, or adjust the Low and High
values independently.
4. Make adjustments by sliding the highlighted circle, touching the + or – buttons.
5. Touch OK to exit back to the main Travel menu.
IMPORTANT: ALT, ROL, PIT and YAW replace THR, AIL, ELE and RUD labels
respectively in multirotor to more closely reflect the flight axis of multirotor aircraft.
To Next Page
Loading...
