SAILPLANE PRE-CONFIGURED MIXES
When Sailplane is selected as the model type, the iX14+ will pre-configure four
commonly used mixes. For the following mixes, it is normal to set the offset close
to or at the end point because of the geometry of sailplane flap servo linkages. It is
also normal to use a significant amount of trim on the flap channels to center the
control surfaces with these configurations.
Aileron to Rudder (AIL > RUD)
The Aileron to Rudder mix is commonly used for coordinated turns. When active, as
aileron is applied, the rudder moves in the same direction as the turn (right aileron
input results in right rudder output). If Switch is assigned to Flight Mode, a second
Switch option allows an additional switch to be assigned to activate up to three
aileron to rudder mixes for each flight mode.
To Next Page
Loading...
