Aileron to Flap (AIL > FLP)
The Aileron to Flap mix allows the entire trailing edge of the wing (aileron and flap)
to operate as ailerons. When active, as aileron is applied, the flaps also move.
Always program the flaps to move in the same direction as the turn (right aileron
input moves the flaps as right ailerons).
Elevator to Flap (ELE > FLP)
Elevator to Flap mix creates additional lift, allowing a tighter turn. The entire trailing
edge of the wing (aileron and flap) operates as flaps (camber increase) when
elevator is applied.
An offset is provided, which is typically used for Snap Flaps. With Snap Flap, no
Elevator to Flap mix occurs until the offset value is reached. Typically, this offset is
at 70% up elevator. Beyond 70% up elevator, the down flap mix activates, providing
additional lift for aggressive turning
(e.g., in tight thermals or racing turns).
To Next Page
Loading...
