Each individual output channel can be mapped to any input channel from the
trainer signal, leaving all other controls on the instructor transmitter. Primary flight
control channels default to instructor control. Leave all channels connected to flight
controls set up as instructor when using a headtracker.
To configure headtracking FPV:
1. Select either Wired or Wireless Trainer from the Trainer menu.
2. Select the FPV trainer mode.
3. Select the switch to enable/disable the head tracker.
4. Select the first Output Channel to be controlled. For example, if the pan servo
is plugged into channel 5, select channel 5 as the output. Each axis of the
gimbal will go to a separate output channel.
5. Change the mode to STUDENT. This selection only applies to the selected
output channel.
To Next Page
Loading...
