6. Select the Input Channel from the trainer that controls the selected output
channel when trainer is activated.
7. Input channels can be reversed or scaled in this menu to configure the student
controls for correct response on the output channels. Normal servo setup menus
for the output channel will be ignored when the trainer signal is commanding a
given channel.
8. Repeat steps 4–7 to configure all the required output channels; select the
Output Channel first, change the mode to Student, select the Input Channel
and scale and reverse the travel as necessary.
9. For wireless connections, touch the Bind button to put the iX14+ into trainer
bind mode before powering on the wireless head tracker (student transmitter).
See the Binding Wireless Trainer section for more information.
To Next Page
Loading...
