• FPV Racer mode optimizes the throttle channel by changing it to 11ms operation
and keeps flight mode functions simple.
• AP mode includes a separate Channel Input Assignment menu tied to each
flight mode. With this capability a pilot can configure the iX14+ in AP mode so
changing the flight mode can change the input source for the camera gimbal. For
example, a pilot can configure flight mode 1 for slow speed flight, flight mode 2
for faster flying and flight mode 3 to put the multirotor into a position hold mode.
The pitch/roll control stick can then be re-assigned to the camera pan and tilt
commands. In this example, the pilot uses the first two flight modes to fly the
aircraft. In those modes, the camera pan and tilt can be assigned to the sliders. In
the third flight mode, the aircraft can take advantage of GPS technology* to hold
a position and the pilot can move the pitch/roll control stick to guide the camera
gimbal without affecting the multirotor.
*GPS technology for position hold are not part of the features of the iX14+. This
function must be installed on the flight controller onboard the aircraft.
To Next Page
Loading...
