Aircraft will not
link (after binding)
to transmitter
Transmitter too near aircraft
during linking process
Move powered transmitter a few
feet from aircraft, disconnect and
reconnect flight battery to aircraft
Aircraft or transmitter is too
close to large metal object
Move the aircraft or transmitter
away from the large metal object
Bind plug left installed in bind
port
Rebind transmitter to the
aircraft and remove the bind
plug before cycling power
Aircraft is bound to different
model memory
Select the correct model
memory on transmitter
Transmitter may have been bound
using different DSM protocol
Bind aircraft to transmitter
Damaged remote receiver or
receiver extension
Required remote receiver is
not connected
To Next Page
Loading...
