Splicecom PCS 552 - Switch to Hands Free; Changing the Volume

PCS 552 User Manual
Basic Call Handling
16 PCS 552 User Manual V3.2/0312/1
Alternatively,
Reject
4
If you do not wish to answer the call press the context sensitive key beside Reject. The
call will be passed to your Forward on Busy number (if set) or passed to voicemail (if
enabled) or cancelled. (Please refer to your System Administrator for further information
on your Forward on Busy number.)
Please note that if you replace your handset while both calls are active you will connect the two calls
together.
Switch to Hands Free
You may wish to switch between hands free and handset operation without interrupting the call.
From handset to hands free – press the Speaker button and replace the handset.
From hands free to handset – lift the handset.
Please note:
 If you press the Speaker button while using hands free you will end the call.
 If your PCS 552 is configured so that your calls can only be handled hands free, when using a headset
in most cases, this feature is not available.
For further information please refer to the Hands free Operation section from page 1.
Changing the volume
You can change the ringing volume and conversation volume at any time during or before a call.
Changing the Volume before a call
Hands free volume
1
Press the Speaker button.
2
Press the Volume Up or Down buttons as required.
3
Press the Speaker button when finished.
Handset volume
1
Lift your handset.
2
Press the Volume Up or Down buttons as required.
3
Replace the handset when finished.
Changing the Ringing Volume
While an incoming call is ringing, press the Volume Up or Down buttons as required.
The ringing volume will increase or decrease.