IP Video Intercom Paging Console User Manual
12
The meanings of the parameters are as follows:
Set the broadcast function ON or OFF, the default is enable; Disabled,terminal
screen has not broadcast module
When enabled, the handset can be hung up to end broadcast.(the default is
disabled)
When setting broadcasting, the input channel of sound source can choose
gooseneck microphone pole, built-in microphone, microphone and line input.
When the broadcasting is set up, the output channel of sound source can be
selected for loudspeaker and line output.
Set the sampling rate of the broadcast
Alarm/ Broadcasting
device
Configure the terminal red emergency broadcast button function, the default is
the “Broadcast” function.
Broadcasting: press the red emergency broadcasting button to initiate
broadcasting to all zones;
Alarm: enable alarm, add a timed alarm task on the scheduled task of the server
to trigger alarm broadcast, press the red emergency broadcast button for 2s, and
all the configured receiving and alarming terminals on the server will sound an
alarm prompt tone.
Monitor parameters
The meanings of the parameters are as follows:
Set up the monitor module ON or OFF, default is enabled. Disabled, terminal
screen have not monitor module.
Note: the monitor module is enabled by default, and the device can be
monitored in permission allowable range. The module should be closed if
user privacy involved in.
When enabled, the handset can be hung up to initiate monitoring.(the default is
disabled)
When setting monitor, the input channel of sound source can choose gooseneck
microphone pole, built-in microphone, microphone and line input.
To Next Page
Loading...
