KGE/EN (1711) 6.5 Introduction 11
KGE
1.4 SPXFLOW service
Should you have any further questions or wish to receive additional explanation regarding
specific matters concerning your pump (adjusting, assembly/disassembly etc.), please
do not hesitate to contact us.
1.5 Symbols used
While following instructions you may notice some of them are only applicable for certain
constructions. That is why following division is maintained:
! Construction 0 and 0+ have different bearings
1.6 Check delivery
Check immediately upon receipt for any damage, and that the goods are conform to the
delivery note. Have the carrier report (in writing) any damage, or missing items. Each
pump has a serial number. Please state this number on all documents and letters.
In case the pump is not immediately put into service, take the necessary measures to
prevent it from seizing up (e.g. periodically rotate the pump shaft several times).
pump size construction symbol
11-3
00
11-4
16-3
0
12b-5
12-5
12-6
15-6
0+ +16-6
14-8
18-4
1
20b-5
22-6 2
Figure 1: Name plate with serial number.
Ø
No.
SPX Flow Technology Assen B.V.
- www.johnson-pump.com
Dr.A.F. Philipsweg 51, NL-9403 AD Assen
CR Nr.04029567
eff.
MEI
≥
To Next Page
Loading...
