SPX CS4000 Mini - Page 14

Contents
May 2002 T-38324-A Page xi
Figure 6-1. VSMain.ini configured for a 485 Network........................................................ 6-2
Figure 6-2. Network Address DIP Switch Set for Address ‘5’............................................ 6-5
Figure 9-1. CS4000 Mini Controller with Ethernet Wiring of Standard Ethernet and
Interbus-S Module........................................................................................... 9-3
Figure 9-2. CS4000 Mini Controller with Ethernet Wiring of Standard Ethernet ............... 9-5
Tables
Table 3-1. Description of Ethernet Interface Card LEDs................................................ 3-15
Table 3-2. Description of LEDs on the Side of the Interbus-S Module........................... 3-17
Table 3-3. Description of LEDs on the Top of the Interbus-S Module............................ 3-17
Table 4-1. 19-Position Remote I/O Connector Pinout Signal Names and Descriptions .. 4-5
Table 4-2. Guidelines for Proper Operation of the Controller I/O Signals........................ 4-8
Table 5-1. Ethernet RJ-45 Modular Jack Pinout ............................................................ 5-16
Table 6-1. Switch Positions Representing Binary Numbers............................................. 6-4
Table 6-2. Setting Address Switches ............................................................................... 6-4
Table 8-1. Replacement Parts ......................................................................................... 8-1
Table 8-2. Ethernet Common Problems and Solutions.................................................... 8-3
Procedures
Procedure 5-1. Programming the Ethernet Interface Card...................................................... 5-2
Procedure 5-2. Editing Application Information...................................................................... 5-10
Procedure 5-3. Editing VSMain.ini for an Ethernet Network.................................................. 5-15
Procedure 5-4. Testing the Network From A Laptop Computer ............................................ 5-17
Procedure 5-5. Testing the Network From A Host Computer................................................ 5-23
Procedure 6-1. Editing VSMain.ini for a 485 Network.............................................................. 6-3
Procedure 6-2. Setting the Address for the Controller............................................................. 6-6