SPX S2045 - Performance Characteristics; Authorization; Standard Construction; Construction Options

Waukesha Cherry-Burrell Introduction
12/2010 95-03080 Page 13
Performance
Characteristics
Authorization
3A/USDA (Sanitary Models)
Standard Construction
• Casing: 316L Stainless Steel
• Port Connections: S-Line
• Backplate: 316L Stainless Steel
• Impeller W/Integral Shaft: 316L Stainless Steel
• Impeller Retainer: 316L Stainless Steel
• Shaft Seal: Single Mechanical, exte
rnally-balanced (Type 1)
• Rotary Seal Material: Carbon
• Stationary Seal: Purebide
• Elastomers: FDA approved FKM
• Finish: All product contact surfaces pr
ovided with a sanitary
polish (20Ra mechanical). The motor adapter bracket is
Nedox coated cast iron.
• Mounting: Close coupled for JM shafted motors
Construction Options
Ports
Buttweld
Flange 150# MSS
Flange 150# ASA
DIN
DIN Form A
SMS
Seal Type
• Water Cascade (Type 1C)
• Double Mechanical with flush (Type 4 Shaft Seal)
• WFI - Special Type 4 shaft seal for water for injection
applications
• Commercially available seals (Contact your WCB
representative for details)
Rotary Seal Material
Purebide
Silicone Carbide
Tungsten Carbide
Stationary Seal
Silicone Carbide
Tungsten Carbide