INTERIOR SWITCHES
4-25
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
• There could be mechanical noises and shocks during mode
changes. However, these are normal conditions due to the mode
changing operations.
• Use only the 2H mode on a normal paved surface. Do not drive
your vehicle in the “4H” position on paved road surfaces. Doing
so will result in damages to the drive train.
• Driving in a 4 wheel mode on a normal paved surface will cause
unwanted noises, premature wear of tires, or increased fuel
consumption.
• If the “4WD CHECK” warning light stays on, have the 4WD sys-
tem checked by the nearest Ssangyong Dealer or Ssangyong
Authorized Service Center.
• When cornering a curved road in a 4-wheel drive mode, there
could be some mechanical shocks and resistances in vehicle’s
drive train. These are normal conditions due to internal resis-
tance in the drive train when the 4-wheel drive mode is properly
working. To avoid damages to the drive train, do not drive your
vehicle at an excessively high speed on a sharply curved road.
4WD HIGH Indicator
• When shifting the driving mode from “2H” to “4H”,
this indicator comes on.
4WD CHECK Warning Indicator
This warning indicator comes on when the ignition
switch is turned to “ON” and should go out if the
system is normal. If the “4WD CHECK” warning in-
dicator stays on, have the 4WD system checked by
the nearest Ssangyong Authorized Service Center.
CAUTIONS WHEN USING 4-WHEEL DRIVE MODE
C100_RHD_04-Interior Switches.p65 2006-05-16, ¿ÀÈÄ 8:2825