INSTRUMENT CLUSTER
5-9
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1. Locate the fuel filter in the engine compartment and place
a water container under it.
2. Disconnect the connector under the drain plug of the wa-
ter separator.
3. Turn the drain plug to the opening direction to drain the
water.
4. Wait until a certain amount of fuel gets out from the port,
then turn the drain plug to the closing direction to tighten it.
5. Engage the connector under the drain plug and press the
priming pump until it becomes rigid.
6. Close the engine hood and start the engine.
HOW TO DRAIN THE WATER FROM THE FUEL FILTER (Without Additional Water Separator)
Priming pump
Fuel filter
Drain plug
Connector
Opening
Closing
Be careful not to be injured by surrounding equipment during the working
procedures.
CAUTION
If the priming pump is not properly operated, air may get into the fuel
line. It may cause a starting problem or fuel system problem. Make
sure to perform the job in step 5.
WARNING
C100_RHD_05-Instrument Panel.p65 2006-05-16, ¿ÀÈÄ 8:299
To Next Page
Loading...
Need help?
General
