Introduction
The STEVAL-WBC2TX50 evaluation board, based on the STWBC2 integrated circuit (IC), is designed for wireless power
transmitter applications and allows its user to quickly start their 5 W Qi BPP, 15 W Qi EPP or 50 W STSC wireless charging
projects.
The STWBC2 wireless transmitter IC can deliver the following power transfer levels of inductive wireless power technology:
• Up to 5 W charging power compatible with Qi 1.3 Baseline Power Profile (BPP)
• Up to 15 W charging power compatible with Qi 1.3 Extended Power Profile (EPP)
• Up to 50 W charging power using the STSC Profile
The BPP and EPP are specified by the Wireless Power Consortium’s Qi specification.
The evaluation board is designed to operate with 5-20 V input voltage or with a USB PD power adapter.
Two interfaces are open to the user: UART for monitoring and control via STSW-WBC2STUDIO graphical user interface (GUI)
and SWD JTAG for direct NVM access. Both interfaces are accessible via the STLINK-V3MINIE bridge.
The STEVAL-WBC2TX50 includes several safety mechanisms providing over temperature (OTP), overcurrent (OCP),
overpower (OPP), overvoltage (OVP) and Vin drop protections as well as foreign object detection (FOD) for reliable designs.
Figure 1. STEVAL-WBC2TX50 evaluation board
STEVAL-WBC2TX50 wireless power transmitter evaluation board
UM3231
User manual
UM3231 - Rev 1 - February 2024
For further information contact your local STMicroelectronics sales office.
www.st.com
To Next Page
Need help?
General
