Appendix C STMod+ GPIO sharing and multiplexing
Table 31 gives the description of the signals available on the STMod+ connector. It also shows which signal is
shared with other board connectors (such as camera, ARDUINO
®
Uno V3, DFSDM or Wi‑Fi
®
). Solder bridges
(SB) are present to manually select which function is wired by default.
Analog signals are in brackets [xxx].
The I
2
C bus is shared with the ARDUINO
®
Uno V3 connectors. It is recommended to check the device slave
address when adding it to the bus.
UM2569
STMod+ GPIO sharing and multiplexing
UM2569 - Rev 1
page 44/54
To Next Page
Loading...
Need help?
General
