ST STM8S

AN2752 Setting up the STM8 development environment
Doc ID 14651 Rev 3 39/42
The LCD display on the STM8 evaluation board indicates a successful debug session (see
Figure 28).
Figure 28. STM8 evaluation board
10.3.6 Follow up
Step by step, additional peripherals of STM8S devices can be run, following on from the
initial debug session described above.
Many features of STM8S devices are supported by dedicated hardware on the STM8
evaluation board. The necessary software drivers (CAN driver, LIN driver, buttons, memory
cards, buzzer, etc) are delivered in the STM8 firmware library.