Setting up the STM8 development environment AN2752
30/42 Doc ID 14651 Rev 3
10 Setting up the STM8 development environment
The STM8 development environment setup looks different depending on the supplier of the
software (SW) and hardware (HW) tools.
Typical setups are described below for the following SW and HW tools:
● STM8 C compiler from Cosmic
● ST toolset and STM8 firmware library from STMicroelectronics
● HW debug interface "Rlink" from Raisonance
● STM8 evaluation board from STMicroelectronics
10.1 Installing the tools
All software tools are delivered with a setup wizard which guides the user through the
installation process. It is recommended to install the tools in the following order:
1. C compiler
2. ST toolset
3. STM8 firmware library
The Rlink does not need any dedicated software installation in the STM8 development
environment because the necessary drivers are delivered with the ST toolset.
Note: These R-link drivers must be launched separately as follows:
Start/Programs/STtoolset/Setup/Install Rlink driver.
To Next Page
Loading...
Need help?
General
