2)
Possible causes:
n Internal temperature too high
n User default Power limiter
n Frequency too high
n Controlled by grid operator (feed-in management)
n Delayed increase in power after starting
3)
Can be reset to 0 via Settings ▶ Reset max. vals.
Acoustic alarm
An acoustic alarm sounds (approx. 4.5 kHz) when an event message
is displayed.
n 2 tones: warning
n 3 tones: error
The acoustic alarm is switched off with the factory default settings.
Backlighting
n off
n automatic: switches on for 30 seconds when a button is
pushed
n Grid feed (factory setting):
– Not feeding: switches on for 30 seconds when a button is
pushed; then switches off
– Feeding: switches on for 30 seconds when a button is
pushed; then dims
TCP/IP network
Notice
– A prerequisite for this is that you know the parameters required for setting up the TCP/IP
network connection. Consult (further) technical professionals if required.
– DHCP is activated in the device ex-works. This allows automatic integration of the device in
most networks.
EN
747,431 | Z09 | 2015-09-30
21
To Next Page
Loading...
