Steca coolcept - Page 44

Reactive power
———————————————————————————
NOTICE
The following items are only displayed when the use of a reactive
power characteristic curve is prescribed for the country currently
selected in the Country item:
n The following items are only displayed when the use of a
reactive power setting is prescribed for the country currently
selected in the Country item:
– Mode: Type of characteristic curve
Select one of the following types:
- cos phi = 1
- Q(P)
- Q(U) linear
- Q(U) hysteresis
– Load samples
1)
: A default characteristic curve can be
selected here.
– No. of nodes
1)
The nodes provide for free programming
of a characteristic curve.
– Node 1
1)
– Node 2
1)
– Node n
1) 2)
– Display char. curve
1)
: Not indicated with mode cos phi = 1.
2)
: Is only displayed when no. of nodes has been set to a
value > 2.
———————————————————————————
1. Press SET to call up the item.
2.
Press rs to select a type of reactive power characteristic
curve.
3. Press SET. The reactive power characteristic curve type is
adopted.
4. Press ESC. The check list is shown.
EN
747,431 | Z09 | 2015-09-30 44