V01-2013 35mm-01 serie
13
HOW TO USE THE STEENBECK 35mm 01-SERIES. (continued)
5.4 DRIVE DECK OVERVIEW ( 2 figures) (fig. 5 page 11)
34 polygon cover cap (support guide ring; not on photo)
35 pressure arm picture left and right
36 pressure arm sound left and right
37 COMOPT sprocket for film with sound
38 push button (red) to detach pressure arm
39 cover plate (lift when threating film)
40 switching between standard image and Cinemascope
41 focus image
42 guide rollers film
43 optical sound reader COMOPT
44 knob for framing by hand. (don’t touch it while running)
For accurate framing it is advisable to operate the editor at a low
speed and employ push button ‘framing’.
45 tension roller; a) for film with sound b) for SEPMAG sound
46 protection cap optical sound lamp (OPT. 2)
47 fly wheels to optimize sound
48 hexagon screws for adjusting picture lamp (see also page 28)
49 tension arm
50 magnetic head for SEPMAG (or placing SEPOPT / OPT. 1)
51 switch for sound-shift system. ST401 - ST701 – ST721 only.
52 lens and prism system
53 screw bearing shaft plate pressure arm (see also page 23)
54 SEPMAG / SEPOPT sprocket
55 interchangeable condensor system (part of the illumination system)
(see also fig. 12 page 29 )
5.5 FUSE PANEL: at the back of the right hand leg (fig. 4 page 10)
56 fuse 6,3 Amps T (220 / 240 volts) or 10 Amps T (110 / 120 volts)
57 fuse 0,5 Amps T for all voltages or 1 Amp T (110 / 120 volts)
58 pilot lamp fuses. (on when a fuses is blown)
59 Interlock (not in use with 01-Series, from 2010 onwards)
60 bi-phase (not in use with 01-Series, from 2010 onwards)
The fuses are located in a holder with bayonet mount.
If a fuse has blown, the pilot lamp (39 page 10) next tot his fuse will be on.
To Next Page
Loading...
Need help?
General
