V01-2013 35mm-01 serie
7
4.0 IMPORTANT SAFETY AND WARRANTY INFORMATION.
4.1 SAFETY:
The installation and maintenance should always be done by Steenbeck factory
engineers or an appointed /certified Steenbeck agent / dealer.
Of highest importance is a well-connected and safe power ground system.
This system has to be in a 100% condition, because of:
- the safety of the user of the Steenbeck 01-Series
- the risk of electronically malfunction both inside and outside the table.
- discharge of static electricity.
The 01-Series should always be placed in a dry room and free from dust.
The temperature should be between 5° C and 40° C (40°F 105°F)
Humidity should be between 30% to 70% (approx.).
A higher humidity can cause corrosion on electronic contacts.
Warning: never put drinks / liquids on the Steenbeck machine.
Liquid spill, when leaking into the machine, can cause great damage and can be
dangerous for its user.
Regularly clean the machine with the brush and the special cleaning wipes (blue is
for wet use and yellow is for dry cleaning). Never use steel cleaning tools.
Never open the machine.
If there is any mechanical or electronically alignment needed, these should be done
by a Steenbeck engineer or by Steenbeck trained staff.
It’s advised to use good trained staff to work with the Steenbeck machine.
It’s very important that this personnel has read and studied the user manual.
IMPORTANT:
There is always a personal danger related to the revolving sprockets.
Beware of this danger when having long hair, necklaces, bracelets,
long sleeves etc.
To Next Page
Loading...
Need help?
General
